Rescue Robot Competition

2016

This is a project for our MTE380 Mechatronics Engineering Design Workshop course. The objective is to send a rescue robot from a base on one side of the “mountain” to a location on the other side of the “mountain” marked by a pole. The “mountain” is a piece of plywood with a ramp on one side and a sheet metal covered section on the other. Our solution to this problem was a lift that carried a small robot over the top and release it on the other side. The lift is controlled by a simple logic circuit with limit switches eliminating the need for a microcontroller. The small robot used a laser range finder to locate the base and uses encoders on both wheels to ensure straight travel.

Connect With Me

Lane Keeping

Hand-Eye Calibration

ICP Pointcloud Matching

Heterogeneous Joint Calibration

Infrastructure Sensor and GPS Calibration

Deep Learning LIDAR Odometry

ADAS Stereo Camera System

Rescue Robot Competition

NXT Domino Laying Robot